Skip to content
Financing and rebates, one phone call (339) 231-8238
HVAC Financing Wakefield logo

Moving off oil and gas

Replacing Oil and Gas Heat in Wakefield

Exchange a tired boiler or furnace for year-round heat pump comfort, with the fate of the old equipment settled and the costs explained up front.

Wrench tightening a fitting on a water heater

Leaving the Old Boiler Behind, Step by Step

An old oil boiler or gas furnace tends to become a source of quiet worry. Fuel prices move, deliveries have to be scheduled and every winter brings the question of whether this is the year it finally quits. Replacing it with a heat pump changes that. One system then covers both seasons, the oil truck stops coming and running costs become something you can plan around. The work is more than a swap, though, and it pays to understand it before you start. First we size the heat pump from your house, not from the old equipment, because older boilers are often far bigger than the home needs. Next comes a joint decision about the old equipment. When the heat pump covers the whole house, the boiler or furnace can be removed or disconnected, and an oil tank can be dealt with as part of the plan. If you would rather keep it as a backup, integrated controls let the heat pump lead and rouse the boiler only when the cold turns severe. Rebate programs have rules about this choice, so we explain how each option fits the program your accounts connect to. In Wakefield that usually means the town light department's rebate, and we check that before any numbers are set. You see the full plan, the price and the paperwork before work begins.

What a Replacement Involves

Every switch is planned around the house, but these steps show up on most of them.

  • Current system review

    Age, fuel, zones and condition of the boiler or furnace noted, along with radiators, baseboard or ducts.

  • Heat pump sizing

    Capacity set from a heat-loss design, so the new system is right-sized for the house.

  • Boiler decision

    Pull it, cap it or keep it as backup, settled before the proposal and in step with whichever program applies.

  • Backup wiring

    If the old system stays, controls that leave the heat pump in charge and bring in the backup only during deep cold.

  • The oil tank

    Whether it comes out, and where that lands in the schedule.

  • Hot water questions

    If the boiler also makes your hot water, how that need will be covered after the change.

  • Rebate fit

    The replacement scope matched to whichever rebate path your accounts allow.

How the Switch Comes Together

  1. Talk about the old system

    Tell us the fuel, the age and what worries you about it. We explain the options for replacing it and keeping or removing it.

  2. Design and decide

    After a visit, you get a written proposal covering the heat pump layout, what happens to the boiler, the price and the rebate picture.

  3. New system in, old one sorted

    We set the heat pump, then pull, shut down or tie in the boiler or furnace as agreed, and close out the paperwork.

Changeover Without Loose Ends

  • A clear plan for the old system

    Nothing about the boiler or tank is left to figure out later.

  • Backup done properly

    The backup only runs when the outdoor temperature truly calls for it.

  • Cost explained in full

    Price, rebate and financing in writing before work starts.

  • Oil, propane and gas
  • Boilers and furnaces
  • Old system handled
  • Backup controls wired

Is This the Winter You Retire the Boiler?

Name the fuel and the rough age of the equipment, and we will outline how a heat pump would take its place and what becomes of the gear you have.